As a new type of energy-saving building materials, glass film has several advantages such as heat insulation, heat preservation, safety explosion-proof, UV protection, glare-proof, easy to create private space, enhance visual effects, and withstand high temperature and fire resistance. So, how do you stick the glass door film? Next, let's take a look at the glass door film construction method skills.
1.Familiar with tools, good size
Construction points: The inspection tool is not missing, and the size of the same side of the window.
The tools we prepared before the filming should include at least four scrapers, watering cans, utility knives, and rulers, and carefully check whether the tools are flat, smooth, and notched; after that, we measure the length and width of the window and measure the size of the window. Must start with the same side of the window.
2.Film
Construction points: The soft cloth on the mat, the edge of the film is aligned with the center line, and the size is 5-8 mm smaller than the glass.
After taking out the size and quantity of the film inspection film, place a small blanket or soft cloth underneath to avoid scratching the floor. When cutting, align the film edge with the center line and cut it. The size of the cut is 5-8mm smaller than the glass size. The back is on the membrane.
3.Cleaning glass
Construction points: more water spray, several times, clean, no dust, no dust, no sand.
The glass must be cleaned, which is very important for the effect of the film. Wash the glass thoroughly. Spray more water, use a film to scrape and scrape several times, so that the glass has no dust, no dust and no sand. After cleaning the glass, spray a layer of water.
4.The upper film
Construction points: Spray the lubricating fluid to reduce the viscosity of the adhesive layer, first cross the cross, first scrape the film between the middle and the back.
The film is divided into two layers, one layer is colorless and transparent, called a protective film, and the other layer is called a film with adhesive color. Before spraying the film, first spray the lubricating liquid to reduce the viscosity of the adhesive layer, then peel off the protective film and apply the film to the position of the film on the glass window. The action is to first cross the cross, then scrape the film from the middle to the sides to fix the film. The bubbles are driven out from both sides, and the force should be light, avoiding excessive force and scratching the film.
5.Scraping the film to catch water
Construction points: small towel to absorb water, trim corners, dry rag to wipe.
Spraying a layer of lubricating liquid on the film, separating the protective film and the film, the direction of action is the same as that of the previous step, vigorously scraping away the moisture, and sucking out the water with a small towel, which is not scraped after the trimming corner is torn. The lower protective film is completed. When all windows are filmed, apply a small amount of detergent to remove other residues. Wipe with a dry rag to make the window smooth and bright.
